Hello Amigurumi followers, I wanted to share free amigurumi models with you on my Amigurumi mobi page. In my article, I share the Amigurumi Gummy Bear Free Pattern for you. In the article on my page, I give detailed information about the Amigurumi pattern;Amigurumi Gummy Bear Free Pattern.
Materials
1-Worsted weight yarn in the color of your choice:
2-I used Brava Worsted
3-4.0 mm crochet hook
4-Poly-fil or any Polyester Stuffing of your choice
5-Yarn Needle
6-Stitch Markers
7-Scissors
Stitches & Abbreviations
1-st/sts – stitch/stitches
2-slst – slip stitch
3-sc – single crochet
4-sc inc – single crochet increase, 2 single crochets in one stitch
5-sc dec – single crochet decrease, single crochet 2 stitches together
6-bbl – bobble stitch
7-Yarn over and insert the hook into the next stitch. Yarn over
and pull through. Yarn over and pull through 2 loops. Repeat
until you have 6 loops on the hook. Yarn over and pull through
all of the loops on the hook. Push the bobble stitch forward
towards you when you sc into the next stitch.
Notes
1-I made this amigurumi doll using the “Yarn Under Single Crochet”
technique. This technique makes the stitches tighter and appears
more aligned.
2-Crochet in continuous rounds. Do not join at the end of each
round. Use a running stitch marker to keep your place when
crocheting in rounds.
3-Use the ultimate finish to close up the back of the amigurumi
gummy bear.
4-Use invisible decreases when making single crochet decreases for a
nicer finish.
5-Optional: invisible increase
6-Finished measurements: approximately 4.5 cm (~1.75 inches)
7-Gauge is not super important for this project as long as you keep
your tension consistent.
8-You can change and use a different yarn weight/category and
appropriate hook size for this project to make it bigger/smaller.
Using a 4.0 mm crochet hook and your color of choice…
Round 1: Magic ring with a base of 6 sc (6 sts)
Round 2: Sc inc in each st around (12 sts)
Round 3: [Sc, sc inc] x 6 times (18 sts)
Round 4: [2 sc, sc inc] x 2 times, bbl, sc, sc inc, sc, bbl, sc inc, [2 sc,
sc inc] x 2 times (24 sts)
Round 5: [Sc, sc dec, sc] x 6 times (18 sts)
Round 6: Sc in each st around (18 sts)
Round 7: 7 sc, bbl, 2 sc, bbl, 7 sc (18 sts)
Round 8: [Sc, sc dec] x 6 times (12 sts)
Round 9: [Sc, sc inc] x 6 times (18 sts)
Round 10: 9 sc, bbl, 8 sc (18 sts)
Round 11: Sc dec, sc, sc dec, bbl, [sc dec, sc] x 2 times, sc dec, bbl,
sc dec, sc (12 sts)
Stuff your amigurumi gummy bear before the opening gets too small.
Round 12: Sc dec in each st around (6 sts)
Cut and fasten off with the ultimate finish to close up the hole.
Did you make your own gummy bear? I’d love to see it! Please share it
All Finished.
